Programming The Remote Control - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Checking the intermediate position I
Intermediate position I may only be moved to/programmed when in the upper
limit position.
Press the DOWN button twice in rapid succession. The curtain runs to the
stored intermediate position I.
Checking the intermediate position II
Intermediate position II may only be moved to/programmed when in the lower
limit position.
Press the UP button twice in rapid succession. The curtain runs to the stored
intermediate position II.
Checking the intermediate position II (venetian blind
mode)
When the venetian blind function is being used, the blind moves in nonmaintained
command mode in order to allow the slats to be positioned more precisely. If you
press and hold a control button for longer than 1 second, the blind will revert to
maintained operation.
Once the programmed intermediate position I is reached, the laths are auto-
matically turned (if intermediate position II has been programmed).
Programming the remote control
Readying the UC520 for programming
a) Ready the UC520 for programming by switching on the power
Switch on the power supply.
The UC520 is ready to programme for 3 minutes.
b)Ready the UC520 for programming with the programming button
Press and hold the programming button for 3 seconds.
The control light indicates that the programming mode has been activated.
The UC520 is ready to programme for 3 minutes.
28