Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation page 32

Assembly and Operating Instructions
Intermediate position I
Note
The intermediate position I can be in any curtain position of your
choosing, situated between the highest and lowest limit position. Both
limit positions must be set before intermediate position I is set.
The curtain runs to the intermediate position I from the upper limit
position.
Setting the intermediate position I
Requirement: The curtain must be in the upper limit position
1. Press and hold the programming button Intermediate position I t.
2. Then press the DOWN button until the desired intermediate position I is
reached. Use the UP and DOWN buttons to make any corrections.
3. Release the programming button Intermediate position I t. The indicator
lamps flash briefly three times.
The intermediate position I is now saved.
Checking the intermediate position I
Press the DOWN button twice within one second.
The curtain runs to the intermediate position I.
Deleting the intermediate position I
Press the programming button Intermediate position I t for longer than 5 sec-
onds. The indicator lamps flash briefly three times.
The intermediate position I is now deleted.
32