Deleting Transmitters - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Deleting transmitters
Deleting transmitters individually
Press the programming button on the master transmitter for 3 seconds.
The shutter/awning/blind will 'nod' to confirm.
Now press the programming button of the transmitter to be deleted for 3 sec-
onds.
The shutter/awning/blind will 'nod' to confirm.
Then press again the programming button of the transmitter to be deleted for
10 seconds.
The shutter/awning/blind will 'nod' to confirm.
The transmitter is now deleted from the UC520.
Deleting all transmitters (except master transmitter)
Press the programming button on the master transmitter for 3 seconds.
The shutter/awning/blind will 'nod' to confirm.
Repress the programming button on the master transmitter for 3 seconds.
The shutter/awning/blind will 'nod' to confirm.
Repress the programming button on the master transmitter for 10 seconds.
The shutter/awning/blind will 'nod' to confirm.
All transmitters (except master transmitter) have been successfully deleted
from the receiver.
Overwriting the master
Switch off the power supply of the UC520 and switch it back on again after 10
seconds, or briefly press the programming button of the UC520.
The UC520 goes into the programming mode for 3 minutes.
Note
To ensure that the new master transmitter is programmed in the desired
UC520 only, all other receivers which are connected to the same power
supply must be deactivated from the programming mode. To do so, af-
ter switching the power back on, execute a drive or stop command us-
ing the transmitter for the given receivers.
Now press the programming button of the new master transmitter for 10 sec-
onds.
The shading solution shifts to confirm.
The new master transmitter is now programmed and the old master transmitter
overwritten.
30