Default Setting; Programming - Becker Centronic UnitControl UC520 Notice De Montage Et D'utilisation

Encoding switch setting:
1. Lower position
2. Lower position
3. Lower position
Programming the memory run times
To program the desired UP run time, press the UP button for at least 6 seconds.
The transmission pilot light flashes briefly three times. This drive command will
now be repeated every 24 hours.
To program the desired DOWN run time, press the DOWN button for at least 6
seconds.
The transmission pilot light will then flash briefly three times. This drive command
will now be repeated every 24 hours.
In the slide switch position „ "]", no automatic drive commands will be execu-
ted. The saved run times are retained.
Note
Overwriting the run times is possible at any time. Repeat the program-
ming phase to set the new desired daily run time.
Deleting the memory run times
To delete the UP and DOWN run time, press the RESET button or the STOP but-
ton for at least 6 seconds.
Note
The memory run times, intermediate position I, and intermediate posi-
tion II can be deleted by pressing the RESET button (with a ballpoint
pen or similar object).
Default setting
Alarm signal function on
Drive controller
Roller shutter/awning operation

Programming

de
en
fr
nl
31