Indicator Lamp; Programming The Transmitter - Becker Centronic SensorControl SC431-II Notice De Montage Et D'utilisation

Indicator lamp

A drive command is signalled by illumination of the indicator lamp.
Green: upward travel - Red: stop - Yellow: Downward travel
When the battery starts to lose power, the indicator lamp flashes when trans-
mitting.
The transmission strength and the radio range decrease as battery power de-
clines. The battery must be replaced if the indicator lamp no longer lights up
when a button is pressed.

Programming the transmitter

Before programming this transmitter, a master transmitter
and the limit positions must be programmed.
1) Programming the master transmitter
a) Readying the receiver for programming
Follow the Assembly and Operating Instructions for the re-
ceiver.
• Switch off the receiver power for 5 seconds, then switch it back on.
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in Programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter whilst in Program-
ming mode until the receiver confirms that programming was successful.
The programming process is now complete.
22 - en