Technical Data - Becker Centronic SensorControl SC431-II Notice De Montage Et D'utilisation

2) Programming additional transmitters
1. Press the programming button of the master transmitter until the re-
ceiver confirms.
2. Then press the programming button of the new transmitter until the re-
ceiver confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
Rated voltage
Battery type
Degree of protection
Permissible ambient temperature
Maximum emitted transmission output
Radio frequency
The maximum radio range on and in the building is up to 10 m, and up to 100
m in the open.

Technical data

3 V DC
CR 2032
IP 20
0 to +55 °C
≤ 25 mW
868.3 MHz
23 - en