Programming The Remote Control - Becker Centronic SensorControl SC431-II Notice De Montage Et D'utilisation

Programming the remote control
Note
Before entering this SC431-II transmitter, be sure that first a master
transmitter was programmed into the receiver and the motor learned
the upper and lower stops.
Learning the master transmitter
a) Put receiver into learn mode
Note
Please refer to the operating instructions for the receiver.
• Switch off the receiver's power supply and reconnect after 5 seconds
or
• Actuate the programming button or the radiocontrolled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
b) Learn master transmitter
Press the programming button of the master transmitter in programming mode
until the receiver acknowledges successful programming.
The learn process is now complete.
Learning additional transmitters
a) Press the programming button of the master transmitter until acknowledge-
ment is given by the receiver.
b) Now press the programming button of the new transmitter until acknowl-
edgement is given by the receiver
c) Then press the programming button of the new transmitter to be learnt once
again.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 10 m outside and inside the building and up
to 100 m in the open.
de
en
fr
nl
17