What To Do If; General Conformity Declaration - Becker Centronic SensorControl SC431-II Notice De Montage Et D'utilisation

Problem
Drive is not functioning.
Control light remains
OFF
Drive is not functioning.
Control light is lit up.
Control light is flashing
permanently.
Control light is flashing
Control light is flashing
permanently
Roller shutter does
not move down during
sunlight hours.
The SC431II does not
execute any automatic
control commands.
The SC431II falls off
the pane.

General conformity declaration

The company BeckerAntriebe GmbH hereby declares that the Centronic Sens-
orControl SC431II in conformity with the basic requirements and other relevant
provisions of Directive R&TTE 1999/5/EC.
For use in the following countries: EU, CH, NO, IS, LI
Subject to technical changes without notice.
What to do if ...?
Cause
1. Battery is discharged.
2. Battery is inserted
incorrectly.
1. Receiver is out of the
radio operating range.
2. The SC431-II is not
programmed in the
receiver
TEST mode is active
Battery power is low
Encoding switches SUN-
LIGHT and TWILIGHT are
both activated in TEST
mode.
1. The SC431-II is set to
manual mode.
2. Sun threshold value is
not exceeded
The SC431-II is set to
manual mode.
Insufficient adhesiveness. Clean the pane carefully.
Remedy
1. Replace battery.
2. Insert battery correctly.
1. Reduce distance to
receiver.
2. Programme the
SC431-II
Deactivate setting mode
Replace battery
Check operating modes.
1. Press the MAN/AUTO
button repeatedly until
the control light lights up
green.
2. Adjust sun threshold
value.
Press the MAN/AUTO
button repeatedly until
the control light lights up
green.
de
en
fr
nl
19