Programming The Transmitter - Becker SC211-II Notice De Montage Et D'utilisation

3. Programming the transmitter

Caution
When programming the transmitter, ensure that the range of
travel of the articulated-arm awning is unobstructed, as it
may extend immediately.
Before programming the SC211-II, a master transmitter
(e.g., SWC241-II) must be programmed on the receiver
(e.g., tubular drive R30/17C PSF(+)), and the limit positions
must be programmed.
The SC211-II is compatible with Becker tubular drives (dia.
45, dia. 58) of type
C PSF(+) with serial numbers 0902... and above, as well as
by the VC420-II and the VC470-II.
The SC211-II has an integrated radio transmitter.
1. After programming the master transmitter, set the wind threshold to the
highest possible setting, since high values may be stored on the SC211-
II from assembly, which are transmitted immediately after programming.
2. Open the SC211-II.
3. Press the programming button of the master transmitter until the re-
ceiver confirms.
4. Press the programming button of the SC211-II until the receiver con-
firms.
5. Now press the programming button of the SC211-II that is to be pro-
grammed again until the receiver confirms.
6. Close the SC211-II.
7. Now set the wind threshold as described in Section "4. Setting the
thresholds".
24 - en