Programming The Initial Angle Of Inclination (Optional) - Becker SC211-II Notice De Montage Et D'utilisation

5. Programming the initial angle of
The articulated-arm awning must be completely still when
programming the initial angle of inclination.
1. Extend the articulated-arm awning to the limit position.
2. Turn off the power to the system.
3. Open the controller.
4. Press the programming button for at least 10 seconds until the LED goes
from green to red briefly and then back to green.
5. Close the controller.
6. Now turn the power to the system back on.
This completes the programming process.
Switching off the angle of inclination
1. Extend the articulated-arm awning to the point where you can reach the
SC211-II.
2. Turn off the power to the system.
3. Open the SC211-II and carefully remove the PCB.
4. Turn the rotary switch to position 0.
5. Slide the PCB back into the SC211-II.
Ensure that the PCB is completely pushed in. After
3 seconds, the controller is ready for operation again.
6. Then press the red button until the LED lights up green briefly.
7. Close the SC211-II.
8. Now turn the power to the system back on.
This completes the process.
Changing the angle of inclination
1. Extend the articulated-arm awning to the limit position.
2. Turn off the power to the system.
3. Set the new release angle (see Section "1. Setting the release angle").
4. Now program the initial angle of inclination (see Section "5. Programming
the initial angle of inclination").
This completes the process.
26 - en
inclination (optional)