Setting The Thresholds - Becker SC211-II Notice De Montage Et D'utilisation

Attention
A threshold must be set which does not exceed the maximum
permitted load for the articulated-arm awning.
1. Extend the articulated-arm awning to the limit position.
2. Place the threshold regulator on the SWC241-II in the middle position.
3. Grasp the front section of the articulated-arm awning and shake it in a
way that represents the force at which you want the articulated-arm awn-
ing to retract, for at least 10 seconds.
4. If the articulated-arm awning remains extended, the wind threshold must
be set to a more sensitive setting and the test repeated.
5. If the articulated-arm awning retracts fully, the threshold is at the correct
setting.
The articulated-arm awning must not be extended for 15
seconds after retraction.

4. Setting the thresholds

25 - en