Programming The Remote Control - Becker Centronic SunWindControl SWC510 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Programming the remote control
Note
Ensure that optimum radio reception is achieved.
The threshold values for sun protection and wind control can be set
with the following transmitters: Centronic SunWindControl SWC441,
SWC411 and SWC545.
If the transmitter's sliding switch is moved from "H" to "S" or vice ver-
sa, the shutter/awning/blind will "nod" to confirm the change.
Setting the SWC510 to programming mode
a) Set the SWC510 to programming mode by switching on the power sup-
ply
Switch on the power supply.
The SWC510 will remain in programming mode for 3 minutes.
b) Set the SWC510 to programming mode using the programming button
Press and hold the programming button for 3 seconds.
The SWC510 will remain in programming mode for 3 minutes.
Programming master transmitter
Press and hold the programming button for 3 seconds while in programming
mode.
The system will confirm the programme setting with a 'nod', i.e. the shutter/
awning/blind moves a few centimetres in one direction and then reverses the
same distance.
This confirmation is hereafter referred to as 'nodding'.
The programming process is now complete.
Note
If a transmitter has already been programmed in the receiver, press the
programming button and hold for 10 seconds.
18