Programming; Intermediate Position - Becker Centronic SunWindControl SWC510 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Now press the programming button on the master transmitter again, this time
keeping it pressed for 10 seconds.
The shutter/awning/blind will 'nod' to confirm.
All transmitters (except master transmitter) have been successfully deleted
from the receiver.
Overwriting the master transmitter
Turn off the power supply to the SWC510 and switch back on after 5 seconds.
The SWC510 goes into programming mode for 3 minutes.
Note
To ensure that the new master transmitter is programmed in the de-
sired SWC510 only, all other receivers which are connected to the same
power supply must be deactivated from the programming mode. To do
so, after switching back on the power supply, execute a control or stop
command using the transmitter for the given receivers.
Now press the programming button of the new master transmitter for 10 sec-
onds.
The shutter will "nod" to confirm.
The new master transmitter has been programmed and the old master transmit-
ter deleted.
Intermediate position
Note
The intermediate position can be set at any given position and lies be-
tween the retracted and extended final positions of the awning. The
intermediate position can only be set after the two final positions have
been set.
The awning is adjusted into the intermediate position from the retract-
ed final position.
Setting the intermediate position
1. Adjust the awning from the retracted final position into the desired intermedi-
ate position.
2. Now press and hold the STOP button. Within 3 seconds also press the EX-
TEND button and keep both buttons pressed.
The awning will "nod" to confirm.
The intermediate position has been stored.
20

Programming