Becker Centronic SunWindControl SWC510 Notice De Montage Et D'utilisation page 21

Adjusting the awning into the intermediate position
1. Press the EXTEND button twice within one second.
The awning will move into the intermediate position.
Deleting the intermediate position
1. Adjust the awning into the intermediate position.
2. Now press and hold the STOP button. Within 3 seconds also press the EX-
TEND button and keep both buttons pressed.
The awning will "nod" to confirm.
The intermediate position has been deleted.
Fabric Tension Position / Tilt Position
Note
Use this function to travel the awning from the extended end position to
the fabric tension position / tilt position. Both end positions have to be
set prior to setting the fabric tension position / tilt position.
The fabric tension position / tilt position is travelled to from the extend-
ed end position.
Setting the fabric tension position / tilt position
1. Travel the awning to the fabric tension position / tilt position.
2. Now press the STOP button and within 3 seconds the retract button, keep
both buttons pressed.
The awning will "nod" to confirm.
The fabric tension position / tilt position has been saved.
Travelling to the fabric tension position / tilt position
Press the retract button twice within one second.
The awning travels to the fabric tension position / tilt position
Deleting the fabric tension position / tilt position
1. Travel the awning to the fabric tension position / tilt position.
2. Now press the STOP button and within 3 seconds the retract button, keep
both buttons pressed.
The awning will "nod" to confirm.
The fabric tension position / tilt position has been deleted.
de
en
fr
nl
21