Changing Batteries - Becker SC211-II Notice De Montage Et D'utilisation

Caution
Extend the articulated-arm awning to the best position for
changing the batteries and then turn off the power to the
system. After you have changed the batteries, turn the
power back on.
1. Undo the housing screw and carefully pull back the cover as far as it will
go.
2. Carefully remove the PCB from the housing.
3. Take out the batteries.
4. Insert the new batteries correctly.
5. Carefully slide the PCB back into the housing.
Ensure that the PCB is completely pushed in. After 3 seconds, the
controller is ready for operation again.
6. Then slide the cover back over the housing and screw the screw back in.

Changing batteries

27 - en