Additional Information; Resetting The Digital Security Code - Sony SPP-206 Mode D'emploi

Additional Information

Resetting the digital security code

You normally do not need to set the digital security code. It is assigned
to your base unit and handset automatically when you charge the
battery pack for the first time (see page 9).
However, in the very unlikely event that you suspect another cordless
telephone using the same security code, you can change the code.
Note
When the battery pack in the handset is completely discharged, or is removed
from the handset, the digital security code will be erased.
In this case, charge the battery pack. A new digital security code will be
assigned automatically.
Tips
• This procedure changes the security code in both the base phone and the
handset.
• You can change the security code as often as desired.
1
Place the handset on the base
phone.
2
Press (INTERCOM) of the base
phone.
3
Pick up the handset for more
than five seconds. Then replace
the handset on the base phone
and keep it as it is for more than
three seconds to complete the
code change.
Additional Information
23
EN