Redialing - Sony SPP-206 Mode D'emploi

Making calls (continued)
If the handset battery becomes weak during a call
You hear a beep and the TALK/BATT LOW lamp on the handset
flashes.
The call will disconnect soon. Replace the handset on the base phone to
charge.
Making calls through the speakerphone
Press (SPEAKERPHONE) on the base
phone.
The LINE lamp lights up.
Dial the phone number.
To adjust the speaker volume,slide the
SPEAKER VOLUME control.
When you're done talking, press
(SPEAKERPHONE) again.
To obtain the best speakerphone performance
• You may not be able to hear the other party's voice in a noisy place.
Therefore, use the speakerphone in a quiet room.
• Do not bring your hand or other object too close to the microphone
or you will hear a shrill noise ("feedback").
• When the speaker volume is loud, or the telephone has been placed
close to a wall, you may find that the volume drops suddenly. This is
due to a circuit in the telephone designed to protect against
feedback. In such cases, lower the speaker volume slightly.

Redialing

1
Press (TALK) or pick up the handset from the base phone.
The TALK/BATT LOW lamp and the dialing keys on the
handset light up.
If you're at the base phone, press (SPEAKERPHONE).
The LINE lamp lights up.
2
Press (REDIAL/PAUSE) to redial the number last dialed.
Note
If the number last dialed exceeds 32 digits, five short error beeps will alert you
that the number cannot be redialed.
To erase the last phone number dialed
Press (REDIAL/PAUSE) twice within five seconds.
The number will be erased from the memory, and you'll hear a long
confirmation beep.
12
EN
Basics
(REDIAL/PAUSE)
(SPEAKERPHONE)
SPEAKER
VOLUME
control
LINE lamp