Basics; Making Calls - Sony SPP-206 Mode D'emploi

Basics

Making calls

TALK/BATT
LOW lamp
VOL switch
(HOLD)
(*TONE)
(REDIAL/PAUSE)
(CHANNEL)
Additional tasks
To
Put a call on hold
Improve reception
Adjust the handset volume
Switch to tone dialing temporarily
* If you hear five short error beeps when you press (CHANNEL), move closer to
the base phone.
Notes
• Before dialing, make sure you can hear the dial tone, otherwise you cannot
dial correctly.
• When the TALK/BATT LOW lamp lights up by pressing (TALK), the LINE
lamp on the base phone lights up simultaneously.
• If you press (TALK) while dialing or storing numbers on the base phone, you
will hear a busy tone.
1
Press (TALK) or pick up the handset
from base phone.
The TALK/BATT LOW lamp on the
handset and the LINE lamp on the
base phone light up. The dialing keys
on the handset light up.
Then you will hear a dial tone. If you
hear beeps, move closer to the base
phone.
2
Dial the phone number.
3
When you are done talking, press
(OFF) or replace the handset on the
base phone.
The TALK/BATT LOW lamp on the
handset and the LINE lamp on the
base phone go off.
Do this
Press (HOLD).
The TALK/BATT LOW lamp flashes slowly.
Press (TALK) to resume the conversation.
Press (CHANNEL)*.
Set the VOL switch.
Press (*TONE) after you are connected. The line
will remain in tone dialing until disconnected.
continued
11
EN
Basics