Step 2: Setting Up The Base Phone - Sony SPP-206 Mode D'emploi

Step 2: Setting up the base phone (continued)
Notes
• Use only the supplied AC-T48 AC power adaptor.
Do not use any other AC power adaptor.
• Connect the AC power adaptor to a continuous power supply.
• Place the base phone close to the AC outlet so that you can easily
unplug the AC power adaptor.
Tips
• If your telephone outlet is not modular, contact your telephone service
company for assistance.
• To remove the wall bracket, press the upper tab.
Choosing the dialing mode
For the telephone to work properly, select an appropriate dialing mode
(tone or pulse).
DIAL MODE switch
Depending on your dialing system, set the DIAL MODE switch as
follows:
If your dialing system is
Tone
Pulse
If you are not sure of your dialing system
Make a trial call with the DIAL MODE switch set to TONE.
If the call connects, leave the switch as it is; otherwise, set to PULSE.
8
EN
Getting Started
Set the switch to
TONE
PULSE
Polarity of the plug
–
+
Modular