Step 2: Setting Up The Base Unit; Choose The Dialing Mode - Sony CALLER ID SPP-ID400 Mode D'emploi

Step 2: Setting up the base unit (continued)
Notes
• Use only the supplied AC-T48 AC power adaptor.
Do not use any other AC power adaptor.
• Connect the AC power adaptor to a continuous power
supply.
• Place the base unit close to the AC outlet so that you
can unplug the AC power adaptor easily.
Tips
• If your telephone outlet isn't modular, contact your
telephone service company for assistance.
• To remove the wall bracket, press the upper tab.

Choose the dialing mode

For the telephone to work properly, select an appropriate dialing mode
(tone or pulse).
Depending on your dialing system, set the DIAL MODE switch as
follows:
If your dialing system is
Tone
Pulse
If you aren't sure of your dialing system
Make a trial call with the DIAL MODE switch set to T.
If the call connects, leave the switch as is; otherwise, set to P.
EN
8
Getting Started
DIAL MODE switch
Set the switch to
T
P
Polarity of the plug
Modular