Specifications - Sony CALLER ID SPP-ID400 Mode D'emploi

Troubleshooting (continued)
Symptom
The CHARGE lamp doesn't
light up when you place the
handset to charge.
The battery duration is short.

Specifications

General
Frequency control
Crystal-controlled PLL
Operation mode
FM, duplex
Operation frequency
Base unit: 43 - 46 MHz (250 µW)
Handset: 48 - 49 MHz (2 mW)
Operating channel
25 channels
Dial signal
Tone, 10 PPS (pulse) selectable
Supplied accessories
See page 5.
Handset
Power source
Rechargeable battery pack BP-T16
Battery life
Standby: Approx. 7 days
Dimensions
Approx. 58 x 201 x 43 mm (w/h/d),
antenna excluded
3
(approx. 2 ⁄
8
Antenna: 105 mm (4
Mass
Approx. 260 g (approx. 9.2 oz), battery
included
Base unit
Power source
DC 9V from AC power adaptor
EN
36
Additional Information
3
x 8 x 1 ⁄ inches)
4
1
⁄ inches)
4
Remedy
• Wipe the charge terminals of the base unit and the
handset with a soft cloth or paper for better contact of
the charge terminals.
• Make sure the handset is placed on the base unit
properly.
• The battery pack was charged less than 12 hours (due
to power failure, etc.).
• The usable life of the battery has expired and needs
replacement.
Battery charging time
Approx. 12 hours
Dimensions
Approx. 142 x 50 x 226 mm (w/h/d),
antenna excluded
(approx. 5
Antenna: 540 mm (21
Mass
Approx. 500 g (approx. 1 lb 2 oz), wall
bracket excluded
Design and specifications are subject to
change without notice.
RECYCLING NICKEL-CADMIUM
BATTERIES
Nickel-Cadmium batteries are recyclable. You
can help preserve our environment by
returning your unwanted batteries to your
nearest Factory Service Center for collection,
recycling or proper disposal.
Note: In some areas the disposal of nickel-
cadmium batteries in household or
business trash may be prohibited.
For the Factory Service Center nearest you
call 416-499-SONY (Canada only)
Caution: Do not handle damaged or leaking
nickel-cadmium batteries.
5
⁄ x 2 x 9 inches)
8
3
⁄ inches)
8
NICKEL-CADMIUM
BATTERY.
BATTERY MUST BE
RECYCLED OR DISPOSED OF
PROPERLY.