Putting On And Exchanging The Attachments; What Can Be Done If The Drive Shaft Of Your Appliance No Longer Rotates - ESGE-Zauberstab M 100 Design Notice D'utilisation

What can be done ...
DE
GB
FR
Should the shaft still not rotate, the fault probably lies elsewhere, and the appliance should be
sent to our repair service.
... if attachments cannot be removed from the shaft? If sticky ingredients such as egg, sugar,
honey are processed, it is best to hold the appliance together with the attachment for a minute or
two in the washing-up water. Water will not harm the housing, but the cable outlet must not get
wet. Clean the appliance as soon as you have finished working.
WARNING: Disconnect the power plug beforehand!
WARNING: Replace damaged attachments immediately. No liability in case of
damaged attachments!
42

Putting on and exchanging the attachments

... if the drive shaft of your appliance no longer rotates? When you
have not used your appliance for a fairly long time the drive shaft may get
stuck due to small foodstuff residues which have hardened and are now
gumming up the lower shaft bearing.
Push the attachment as straight as possible on to the
Place your ESGE-Zauberstab
a way that the drive pin on the stub fits exactly into the
and a mild detergent, then switch it on. In general your ESGE-Zauberstab
in the socket of the attachment. The attachment is des
will then work again; if not, just try to free the shaft carefully with pliers.
make this process easy. The attachment is removed b
pulling it off from the stub.
Careful: For safety's sake, when you exchange the
always pull out the plug.
... if attachments do not hold tight on the shaft? If an attachment
It can happen that the attachments in time no longer
no longer fits tightly on the stub, simply pinch the spring blades of the
on the shaft. In this case simply press the spring blade
attachment together with a pair of pliers. Remove the accessories from
together with a pair of pliers.
time to time from the shaft and clean the shaft. Otherwise the lower
socket may be blocked because of insufficient cleaning.
Receptacles
You can work in any receptacle, even directly in a pan
stove. Use small receptacles for small amounts and la
receptacles for larger amounts. Narrow, high receptac
more suitable for working in than wide, shallow ones.
What can be done...
if the drive shaft of your appliance no longer rotates?
When you have not used your appliance for some tim
shaft may get stuck due to minute foodstuff residues w
hardened and are now gumming up the lower shaft b
Place the operative part of the appliance for 5 to 10 m
jug with hot water, then switch it on. In general the ap
then work again; if not, just try to free the shaft careful
pliers.
for about 5 minutes in a jug with hot water
®
®