Dräger X-dock 5300 Notice D'utilisation page 30

Maintenance
6.3 Charging function for gas detectors of
the X-am series (optional)
Gas detector Charging module
X-am 2000 X-am 125+ module
X-am 2500
X-am 5000
X-am 5600
X-am 3500 X-am 8000+ module
X-am 8000
1 With the rechargeable battery completely empty.
2 A new NiMH supply unit reaches its full capacity after 3 full
charge/discharge cycles.
The station offers 2 different charging functions:
Charge after 15 minutes of inactivity

Direct charging of a switched off gas detector

To charge a gas detector using a X-am 125+ module after a
test:
1. Place the gas detector in the X-am 125+ module.
2. Close the module flap.
The instrument will be detected automatically.
After the instrument is inserted, the charging status is

displayed for approx. 5 seconds via the charging status
LED.
The charging function starts automatically approx.

15 minutes after the last test.
The station additionally offers an option for directly charging
switched-off gas detectors with no waiting period. If this option
is activated, the gas detectors will not be automatically
switched on when inserted into the modules. The X-am 125+/
8000+ modules then start charging directly.
To charge a switched-off gas detector directly using an
X-am 125+/8000+ module:
1. Activate the option Do not switch on device on the station
(see Technical Manual).
2. Insert the switched-off gas detector in the X-am 125+/
8000+ module.
3. Close the module flap.
The gas detector will be detected automatically and
charged directly.
30
If an error occurs:


1
Charging time
!
2
approx. 4 h
approx. 9-10 h
i i
Overview of charge status LEDs
Colour
green
green
red
Remove from the module and re-insert.
If this does not correct the error, have the module repaired.
CAUTION
With X-am 125+ charging modules only: A short-circuit
in the charging contacts in the modules, e. g. due to
metal objects falling into the device, will not damage
the station but should be avoided due to a potential risk
of overheating and error displays on the module.
NOTICE
With X-am 8000+ charging modules only: Metal
objects in the charging cradle can have a negative
impact on the charging function, and may lead to an
error or prevent that the gas detector is charged.
Status
on continuously
flashing
flashing
Meaning
Charge status 100 %
Battery charging.
Charging error
Dräger X-dock 5300/6300/6600