For Your Safety; General Safety Notes; Definitions Of Alert Icons; Feature Description - Dräger X-dock 5300 Notice D'utilisation

1

For your safety

1.1

General safety notes

Before using this product, carefully read these Instructions

for Use and those of the associated products.
Strictly follow the Instructions for Use. The user must fully

understand and strictly observe the instructions. Use the
product only for the purposes specified in the Intended use
section of this document.
Do not dispose of the Instructions for Use. Ensure that they

are retained and appropriately used by the product user.
Only trained and competent users are permitted to use this

product.
Comply with all local and national rules and regulations

associated with this product.
Only trained and competent personnel are permitted to

inspect, repair and service the product. Dräger recommend
a Dräger service contract for all maintenance activities and
that all repairs are carried out by Dräger.
Only trained and competent personnel are permitted to

inspect, repair and service the product as detailed in these
Instructions for Use.
Use only genuine Dräger spare parts and accessories, or

the proper functioning of the product may be impaired.
Do not use a faulty or incomplete product. Do not modify

the product.
Notify Dräger in the event of any component fault or failure.

1.2

Definitions of alert icons

The following alert icons are used in this document to provide
and highlight areas of the associated text that require a greater
awareness by the user. A definition of the meaning of each
icon is as follows:
WARNING
!
Indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION
!
Indicates a potentially hazardous situation which, if not
avoided, could result in physical injury, or damage to
the product or environment. It may also be used to
alert against unsafe practices.
NOTICE
i
i
Indicates additional information on how to use the
product.
Dräger X-dock 5300/6300/6600
2 Description
2.1 Product overview (see fold-out)
1 Master
2 Module
3 Status LED
4 Touchscreen display
5 Function key
6 Fresh air inlet with filter
7 Antitheft slot
8 Power supply
9 USB ports
10 Ethernet port
11 Mini USB port
12 Exhaust
13 Gas inlets
14 Compressed air inlet
15 Type plate
16 X-am 125 module
17 Charge status LED
18 X-am 125+ module (with charging function)
19 Pac module
2.2

Feature description

2.2.1 Master
The master assumes control of the sequencing of the
maintenance station for functional testing, calibration and
adjustment, as well as functions for user management,
instrument management, printing of standard reports and
standard certificates (using PostScript, Office Jet and PCL
printers only), and also the user interface.
2.2.2 Modules
The instrument-specific interfaces such as, e. g., IR
communication, gas exposure unit and charging contact are
integrated into the modules. In addition, the modules contain
sensors for detecting the visual, audible and vibration alarms
on the instruments.
2.3

Intended use

The Dräger X-dock 5300/6300/6600 is a maintenance station
of modular construction. The X-dock can be used to perform
automated calibrations, adjustments and bump tests on
portable gas detectors in parallel and independently from one
another. A system consists of one master for 3 (X-dock 5300/
6300) or 6 (X-dock 6600) test gases. The X-dock 5300
consists of a master station with one module and cannot be
expanded. Up to 10 modules can be connected to the
X-dock 6300 and 6600 master, depending on the module type.
The modules automatically detect when an instrument has
been inserted and control the gas supply so that an
appropriate supply to the instrument is ensured at all times.
For your safety
19