Inspection Record - Tractel Guard trac WP Manuel D'installation, D'emploi Et D'entretien

Category No. Check:
1. Installation For guard trac™ WP:
1.1 That 1 counterweight is installed in the space further from the guardrail on the
long brackets.
For guard trac™ WP:
1.2
That 2 in-line counterweights are installed on long brackets.
For guard trac™ WPS:
1.3
That 2 stacked counterweights are installed on short brackets.
The presence of anti-slip pad on short and long brackets.
1.4
1.5 The presence of the pin on the adjustable guardrails.
The contact between the lower surface of the washer welded at the barriers and
1.6
the upper surface of the long bracket tubes.
1.7 That there is contact between the brackets and the parapet.
The presence of the clamping wedge and its spring in each short and long
1.8
bracket.
For guard trac™ WPS:
1.9 The presence of the counterweight interface between each stacked
counterweight.
1.10 The good condition of the counterweights.
1.11 That no component is deformed.
1.12 The absence of abnormal corrosion.
2. Manual
2.1 The good legibility of the manual.
2.2 That the inspection sheet is filled in correctly.
3. Marking
3.1 That all markings are legible.
3.2 The presence of the identification plate of the installation completely filled in.
4. Fill in
A Inspector's name.
B Date of inspection.
C Inspection OK = YES/NO.
D Faults eliminated on date.
E Validation issued on date.
F Inspector's signature.
G Next inspection on = E + 1 to mention on the identification plate of the installation

14. Inspection record

GB
19