Regulations And Standards - Tractel Guard trac WP Manuel D'installation, D'emploi Et D'entretien

to regular inspection during the previous 12
months by a technician who has authorised
its return to use in writing (see section 8).
5. To use the guard trac™ WP or guard trac™
WPS guardrail for any purpose other than
the one it is designed for.
6. To use any other 25 kg counterweight than
the ones especially designed for use on
the guard trac™ WP or guard trac™ WPS
guardrail.
7. To install the guard trac™ WP or guard
GB
trac™ WPS guardrail on a structure that
was not subject to a preliminary study (see
section 6) or one where the studies findings
were unfavourable to the installation of the
guardrail.
8. To install the guard trac™ WP or guard
trac™ WPS guardrail in any way other than
the one described in this manual.
9. To use the guard trac™ WP or guard trac™
WPS guardrail if one or more 25Kg counter-
weights are not in place on the bracket and
correctly placed.
10. To install the guard trac™ WP or guard
trac™ WPS guardrail on any waterproof
surface other than the ones described in
this manual.
11. To install the guard trac™ WP or guard
trac™ WPS guardrail on any surfaces with
a slope bigger than 10°.
12. To install the guard trac™ WP or guard
trac™ WPS in a zone without a parapet of
at least 150mm.
DANGER: In cases where there is no
parapet or where this is less than 150
mm high, the guard trac™ t-b barrier
shall be used, which is not the object of this
manual.
13. To use the guard trac™ WP or guard trac™
WPS guardrail that has arrested a falling
person or object and not been put back into
use according to this manual.
14. To use the guard trac™ WP or guard trac™
WPS guardrail in an explosive atmosphere.
15. To use the guard trac™ WP or guard trac™
WPS guardrail in a highly corrosive atmos-
phere.
16. To use the guard trac™ WP or guard trac™
WPS guardrail outside a temperature range
of between -30 °C and +60 °C,
17. To use the guard trac™ WP or guard trac™
WPS guardrail as an anchor point.
16
18. To use the guard trac™ WP or guard trac™
WPS guardrail for hanging tools.
19. To place an interface between the 25 kg
counterweight and the roof sealant during
installation,
20. To install the guard trac™ WP or guard
trac™ WPS guardrail on a roof surface
that has not been previously cleared and
cleaned,
21. To carry out repairs on the guard trac™ WP
or guard trac™ WPS guardrail.
22. To install or use the guard trac™ WP or
guard trac™ WPS guardrail if you are not
fit and healthy, both physically and mentally.
23. To install or use of the guard trac™ WP or
guard trac™ WPS guardrail if a rescue plan
has not been prepared previously in the
event of an operator fall.
24. To use the guard trac™ WP or guard trac™
WPS guardrail if the installation surface is
contaminated with grease, oil, foam, algae
or any other product that might facilitate slid-
ing on the roof sealant.
25. To use the guard trac™ WP or guard trac™
WPS guardrail if the locking pins on the ad-
justable barriers are not correctly located.
26. To use the guard trac™ WP or guard trac™
WPS guardrail if the barriers are not prop-
erly locked into their position inside the
brackets.
27. To use the guard trac™ WP or guard trac™
WPS guardrail if the opening between the
end guardrail and other structures is greater
than 120 mm.
28. To carry out modifications on the guard
trac™ WP or guard trac™ WPS guardrail.
29. To use parts and components other than
those supplied by Tractel®.
30. To use the short bracket for guard trac™ WP
guardrails.

10. Regulations and standards

Tractel® Ibérica S.A. Crta. Del Medio, 265
08907 L'Hospitalet de Llobregat (Spain), hereby
declares that:
– The guard trac™ WP and guard trac™
WPS guardrail is EN13374-A of March 2021
certified.
This equipment has been type tested by a no-
tified body: DEKRA Testing and Certification
GmbH – 44809 Bochum, Germany.