Data Input - ABB FXL5000 Manuel De Mise En Service, D'opération Et D'entretien

6.5
Sub-menu/parameter
Prog. protection
off
Language
English
Nominal size
DN 15
QmaxDN
100 l/min
Qmax
60 l/min
Unit
l/min
Damping
5.0 s
Low flow cut-off
1 %
Prog. input
Ext. cut-off
D184B112U04 FXL5000 (Miniflow)

Data input

Type of input
tabular
Prog. protection
off
Prog. protection
on
tabular
Language
English
tabular
for information only
numerical
tabular
numerical
numerical
tabular
Comment
On / off
If the prog. protection has been switched off, parameters can
be changed. Exit the sub-menu using
German/English/French/Spanish
(Default value is German)
Use arrow key to select the language required and confirm using
.
DN 10, 15, 25, 50
refer to type plate
Max. end value in measurement range which can be set for the
nominal size selected (=10 m/s).
Definition is undertaken automatically using nominal size
End value in measurement range for forward and reverse
(Default value here is QmaxDN)
min. measurement range 0-0.5 m/s;
max. measurement range 0-10 m/s
The unit is selected in the "Unit" sub-menu
l/s; l/min; l/h; gal/s; gal/min; gal/h
(Default value is l/min)
Can be set to between 5 and 40 seconds. The damping
corresponds to the response time of the 20 mA output for
0-99 % flow change. (
Default value is 5 sec.)
Range of between 0 and 10 % of set measurement range. Effec-
tive for the reading in the display and all outputs. If the value falls
below the low flow cut-off, then there is no flow measurement.
Overlap of low flow cut-off: 1 %
(Default value for low flow volume is 1 %)
External output cut-off or external counter reset or no function.
This menu only appears if the function is available; i.e. if this
option is ordered. The 20 mA output is then not used. Comment: If
05 is specified as the "Variant" on the type plate, then this function
is available.
(Default value for prog. input is "No function")
6 Operation
#
GB 21