Permissible Fluids; Safety Labels And Symbols, Type Plates, Factory Panels And Ce Mark - ABB FXL5000 Manuel De Mise En Service, D'opération Et D'entretien

•
•
•
1.1.4
•
•
•
1.1.5
All safety labels, symbols and the type plate should be kept legible and replaced if damaged or lost. Note
the following general information:
GB 4 FXL5000 (Miniflow)
The flow recorder must not be operated close to strong electro-magnetic fields, e.g. motors, pumps,
transformers etc. A minimum distance of approx. 100 cm should be observed.
When fitting on or to steel parts (e.g. steel carriers), a minimum distance of 100 mm should be
observed. (Values have been determined on the basis of IEC801-2 and/or IEC TC 77B (SEC101).)
The max. tightening torque for the process connection (the thread) should be observed. (see page
GB 13)

Permissible fluids

Process media (fluids) may only be used iff, depending on state-off-the-art technology or the operat-
ing experience of the operator, it can be assured that the chemical and physical properties (required)
for operating safety) of the materials of the components coming into contact with the media (mea-
surement electrode, grounding electodes, cladding, connection part, protective panel and/or protec-
tive flange) assure a operating period of succesful operation.
Measuring agents (fluids) with unknown properties or abrasive measuring agents may only be used
if the operator can perform regular and suitable tests to assure the safe condition of the equipment.
The information on the type plate should be noted.

Safety labels and symbols, type plates, factory panels and CE mark

Warning!
STOP
Caution!
!
Notice!
!
Important!
(or Tip)
CE-mark
Indicates a risk or potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation or alerts against unsafe prac-
tices which, if not avoided, may result in injury of persons or property dam-
age.
Indicates a potentially harmful situation which, if not avoided, may result
in damage of the product itself or of adjacent objects.
Indicates useful hints or other special information which, if not observed,
could lead to a decline in operating convenience or affect the functionality
(does not indicate a dangerous or harmful situation).
Example: „Read-made C-routines are available on the support disk."
The CE mark symbolises that the equipment corresponds to the following
guidlines and satisfies their fundamental safety requirements:
• CE-mark on type plate (on the measurement trasmitter)
– declaration of conformity with EMC guideline 89/336/EWG
• CE-mark on factory panel (on the measurement recorder)
– conformity with PressureEquipmentDirective (DGRL) 97/23/EG
The factory panel of pressure equipment does not include the CE mark, if
e.g.:
– the max. permissible pressure (PS) is less than 0.5 bar.
– no registration procedure is needed as a result of low pressure risk
(nominal size ≤ DN 25 / 1").
1 Safety instructions
D184B112U04