Intended Use - VOLTCRAFT VC-539 Mode D'emploi

2. INTENDED USE

Use this product to measure and display electrical values for Overvoltage Category III (up to max.
600 V against ground potential, in compliance with EN 61010-1) and all lower categories. The
product has the following measuring functions/ranges:
• Direct current voltages and alternating current voltages up to max. 600 V (CAT III)
• Direct current and alternating current up to max. 80 A
• Resistance up to max. 40 MΩ
• Capacitance up to max. 100 µF
• Frequencies up to max. 10 MHz
• Diode test
• Continuity test
• Duty cycle
Current is measured using a magnetic sensor. All other measurements are conducted using the
included safety test leads (in compliance with EN 61010-031). The product has an LC display
with 4000 counts and backlighting, automatic range selection and a HOLD function to freeze the
displayed measurement.
The product is supplied with power via two AAA batteries.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms,
must be avoided under all circumstances.
This product complies with the statutory national and European requirements.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you
use the product for purposes other than those described above, the product may be damaged. In
addition, improper use can cause hazards such as short circuiting, fire, electric shock etc. Read the
instructions carefully and keep them. Make this product available to third parties only together with
its operating instructions.
Observe all safety instructions and information within this operating manual.
26