VOLTCRAFT VC-539 Mode D'emploi page 37

Capacitance
To prevent the risk of electric shock, make sure that the capacitor under test is
completely discharged and voltage-free. Risk of electric shock!
1. To reset the display to zero, push the ZERO button (12) before measurement.
2. Connect the test prods to the object under test.
3. The reading is shown on the LC display (10). Wait until the reading stabilizes.
If the LC display shows OL (overload), the measurement range was exceeded.
4. Remove the test leads from the object under test after measurement and turn off the current
clamp.
d) Voltage
1. Use the mode switch (4) to select the measurement mode for voltage.
2. Remove the safety caps from the L-shaped test lead jacks.
3. Connect the red test lead to the red test lead jack (7).
4. Connect the black test lead to the black test lead jack (8).
Measuring voltage
37