Installation - Assa Abloy OneSystem Instructions De Montage

Installation

Warning!
!
Life-threatening danger and risk of injury resulting from incorrect or faulty in-
stallation of the horizontal push rod in accordance with DIN EN 1125: The nor-
mal installation height for the horizontal push rod is 900 mm to 1100 mm above
the finished floor surface. If children are present in the majority of the building,
the installation high must be reduced accordingly. The horizontal push rod must
be installed such that the greatest possible effective bar length is achieved
("Accessories, warranty, disposal", page 67).
Life-threatening danger and risk of injury resulting from incorrect or faulty
installation of door handle fittings according to DIN EN 179: Only escutcheons,
lock counterparts and coverings approved according to DIN EN 179 may be used
("Fittings", page 60).
A
Attention!
Functional limitation due to faulty recess of the lock pocket: The lock pocket
must be created corresponding to the lock pocket dimensions. You must insert
the lock without using any force and screw it into place, so that is not subject to
mechanical stress.
Property damage after drilling through the lock: The lock is damaged by drill-
ing. You may only use existing holes drilled at the factory to attach fittings. The
lock must be removed for any work on the door leaf, such as drilling or cutting.
Damage from dirt: The lock is damaged by dirt. Prior to installation, the lock
pocket and all holes must be cleaned (by blowing out or vacuuming).
Functional limitation due to distorted installation: The lock must be installed
free of torsion.
Functional limitation due to door handles not moving freely: The lock must be
fitted in such a way that the handle spindle and the spindle hub align.
Property damage due to forceful installation of the handle pin into the fol-
lower: The door handle spindle must be gently inserted into the spindle hub. No
tools are needed.
EN
52 Safety instructions