Life & Mobility Match Mode D'emploi page 35

Settings and adjustments
Legrests
The Match can be fitted with a central legrest
or a front bridge to install comfort legrests.
Legrest depth adjustment
For central legrest depth adjustment see
'Seat depth', page 18.
The comfort legrests adapters can be
adjusted independently and seamlessly.
1. Loosen the socket screw (C) on the
bottom of the front bridge.
2. Set the preferred seat depth.
3. Tighten the socket screw.
4. Repeat this for the other side.
Legrest height adjustment
Adjustment of the legrest height is decided
by the height of moulded seat: the vertical
distance top of installation plate - bottom
lower leg on the front of the moulded seat.
Suspension (D) can be raised or lowered by
rotating the front bridge or by installing a
standard or raised adapter.
Legrest width adjustment
1. Loosen the socket screw (D) on the
bottom of the front bridge.
2. Adjust to the desired width.
3. Tighten the socket screw.
4. Repeat this for the other side.
EN28
C
Lower leg length adjustment
Legrest depth adjustment
D
Legrest height adjustment
Securing the ankle hinge
E
Legrest width adjustment
Headrest height adjustment
F
1
ø 3 mm
2 3
B
A
Settings and adjustments
Lower leg length adjustment
1. Loosen the socket screw (F) a turn.
2. Set the preferred lower leg length.
Attention: take a distance of at least 5 cm
to the floor into account.
3. Retighten the socket screw.
Securing the ankle hinge
1. Adjust the desired ankle angle.
2. Drill a hole in the hinge.
3. Secure the ankle hinge with a fastening
pin.
Heel strap/continuous foot support
Attention:
• Prevent the feet of the user from
ending up between the two foot
supports. There is a heel strap or a
continuous foot support available for
this purpose.
Headrest
The headrest can be installed at exactly
the right position by means of the standard
hinge points.
Headrest height adjustment
1. Pull the control handle (A) up.
2. Adjust the headrest to the correct height.
3. Move the control handle (A) back down.
Adjust the headrest height to the individual
position
After having been removed, the headrest can
always be moved back to the right height
immediately by adjusting the stop block.
1. Loosen the socket screw (B).
2. Slide the block (B).
3. Retighten the socket screw (B).
EN29