Life & Mobility Match Mode D'emploi page 34

Settings and adjustments
Rear track width adjustment
1. Loosen the 4 socket screws (B).
2. Slide the rear wheel with the frame tube
in or out to the track width desired.
3. Retighten the socket screws.
4. Repeat this with the other rear wheel;
both rear wheels must be adjusted to the
exact same width using the graduated
marks.
Front wheels
The track width of the front wheels is
adjustable by rotating the front legs inward or
outward around the pivot point. This creates
more room to position the feet between the
front wheels.
Front track width adjustment
1. Loosen the socket screw (C).
2. Rotate the front leg with the front wheel
to the track width desired using the
setscrews (D) on the inside and outside of
the hinge.
Attention: Turn the two set screws (D) on
the inside and outside tightly against the
rotating part of the leg: this is the rotation
stop.
3. Retighten the socket screw (C).
4. Repeat this with the other front leg; both
front legs must be adjusted to the same
angle using the graduated marks (E).
Wheel position
There are two bore positions for the two
wheel sizes (see fig.). The seat height of the
Self-propelled Match is here independent of
wheel size.
EN26
B
Rear track width adjustment
E
C D
Front track width adjustment
1
2
Self­propelled
A
Armrest height adjustment
B
Armrest depth adjustment
Settings and adjustments
SUPPORT
Armrests
The height, depth and width of the armrests can
be adjusted (see 'seat width', pages 17 & 18).
Armrest height adjustment
You can choose from 2 heights of the armrest
system in order to get the desired armrest
height; it consists of an armrest elbow and a
T-piece.
Preferred armrest Armrest system
height
Armrest elbow 1 +
17-25 cm
T-piece 1
24-40 cm Armrest elbow 2 +
T-piece 2
The height of the armrest can be seamlessly
adjusted for each armrest system.
1. Loosen the socket screw (A) on the front
of the armrest system a few turns.
2. Adjust the armrest to the correct height.
3. Retighten the socket screw.
4. Repeat this for the other armrest.
5. Both armrests can be adjusted to the
same height using the graduated marks.
Armrest depth adjustment
1. Loosen the screws (B) entirely (other hole
in armrest) or partially (using the slot).
2. Set the seat depth required.
3. Retighten the screws.
4. Repeat this for the other armrest.
EN27