Life & Mobility Match Mode D'emploi page 30

Settings and adjustments
Adjust seat width
1. Loosen the socket screw (D).
2. Slide the armrest elbow in or out to the
seat width desired.
3. Retighten the socket screw (D).
4. Repeat on other side.
Seat depth
The seat depth can be adjusted seamlessly
for seat depths between 40 and 65 cm by
sliding the legrest suspension.
Adjust seat depth
1. Loosen the socket screw (E).
2. Slide the legrest or the front bridge in
or out until the desired seat depth is
reached.
3. Retighten the socket screw.
Seat height
A selection can be made from 4 different
seat height-adjustment column lengths (F) to
realise the desired seat height for the user.
Preferred seat height Seat height
column
30-38 cm 1
36-44 cm 2
3
44-52 cm
4
52-60 cm
Attention:
• At the lowest setting of seat height
adjustment column 1 (the shortest one):
• The clearance under the foot
support can be limited by a small
knee angle.
• The seat angle tilt range forward
is limited to 0˚ (instead of ­5˚).
EN18
D
Adjust seat width
A
E
Seat height adjustment
Adjust seat depth
F
Adjustment block
Seat height column
Settings and adjustments
Tip:
• The seat height is still continuously
adjustable for 8 cm in each seat height
adjustment column. If the final seat
height is still unknown, we therefore
recommend selecting a longer seat
height adjustment column.
Seat height adjustment
1. Loosen the 2 socket screws (A) in the
frame.
2. Lift the seat frame from the riding frame
with the seat height adjustment columns.
3. Loosen the socket screw (B) on the
adjustment block in the seat height
adjustment column (C).
4. Line up the bottom edge (D) of the
adjustment block with the graduated
marks for the correct seat height.
Attention: At the adjustment block at the
lowest seat height of the shortest column
(column 1) a M5x10 set screw has to be
B
used instead of a cylinder screw with
C
washer.
5. Retighten the socket screw (8).
C
D
6. Repeat the above-mentioned for the
other seat height adjustment column.
7. Lower the two seat height adjustment
columns into
adjustment block rubs.
8. Secure the seating height adjustment
columns by tightening the 2 socket bolts
(A) of the two seat height adjustment
columns again (first the lower socket bolts
on both sides, then the upper ones).
Seat tilt range
To utilise the full back tilt range of the Self-
propelled Match, the following settings may
be used. The tilt range is greater:
the frame until the
EN19