Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Settings and adjustments
•
.. at a higher seat height (from SH 48 cm
full tilt range).
•
.. the further you adjust the balance
point forward.
•
.. if the track width matches moulded
seat width.
•
.. if the armrest depth is moved front-
wards.
•
.. when the P-shaped armrest is used.
Backrest angle adjustment:
The backrest angle of the seat frame is
adjustable and can therefore be adapted to
the backrest angle of the moulded seat.
Attention:
•
After changing the backrest angle,
the seat angle indicator has to be
recalibrated.
Adjust the backrest angle:
1. Loosen the socket screws (E) on either
side of the backrest hinge.
Attention: secure the back support tube!
2. Change the backrest angle.
Attention: the teeth of the two gear shift
discs must completely mesh with each
other.
3. Tighten the socket screws (E) on either
side again.
Balance point settings
The seat frame can slide forward and
backward from the riding frame, with the
occupant and all seat support components in
it. This allows for adjustment of the centre of
gravity position of the user in the moulded
seat with respect to the driving frame.
EN20
E
Adjust the backrest angle:
Settings and adjustments
Warning:
•
Only adjust the balance point with the
occupant in the moulded seat in horizontal
position, thus 0˚ tilt.
Be careful:
•
If the knee angle is very small, the legrest may
rub against the damper suspension in the
extreme rear balance point position.
Attention:
•
When using the seat angle tilt, the position
of the centre of gravity ends up further
to the rear of the chassis, so you must
therefore always make sure you follow our
safety recommendations for balance point
adjustment (the length of the arrow is not an
indication for the amount of movement, only
for the direction of movement).
Balance point setting
Red
recommendation on factory settings
Relatively low seat depth
User physique:
- leg weight relatively high
- torso weight relatively high
Frontward and backward mobility
relatively high
Back moulded seat relatively thick
A relatively high number of slopes
during use
Seat angle used most frequently
relatively large
14
12
10
8
6
4
Balance point callibration
2
0
4
6
8
10
12
•
Extra luggage influences the position of the
balance point, keep this in mind when callibrating
the balance point.
Green
2
0
14
EN21
Publicité
Chapitres
Table des Matières
