Leds On Battery; Assembling The Lawn Mower; Attaching The Handlebar - Stihl Rma 348.0 Notice D'emploi

English
formance, note the recommended temperature
ranges, 20.5. The actual charging time may
differ from the specified charging time. For infor‐
mation on charging times, see www.stihl.com/
charging-times.
► Charge the battery as described in the instruc‐
tion manual for the STIHL AL 101, AL 301,
AL 501 charger.
6.2 Displaying the state of charge
1
► Depress the pushbutton (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.1.
There is a malfunction in the mower or battery.
7 Assembling the Lawn
Mower
7.1

Attaching the handlebar

WARNING
■ When attaching the handlebar, fingers or other
body parts may get caught between the parts
of the handlebar.
► Work carefully.
► Switch off the lawn mower and remove the
batteries.
► Place the lawn mower on a level surface.
10
► Align the upper handlebar (1) and lower han‐
80-100%
60-80%
► Insert the screws (5) on both sides and align
40-60%
20-40%
► Screw on the star knob nuts (6) on both sides
0-20%
► Push the cable (7) into the holder (8).
The handlebar does not need to be removed
again.
7.2
7.2.1
► Switch off the lawn mower and remove the
► Place the lawn mower on a level surface.
► If an extension is attached, detach the exten‐
► If a mulching insert is in place: remove the
► Open the discharge flap (1) and hold it open.
► Take hold of the grass catcher box (2) by the
► Lower the discharge flap (1) onto the grass
7.2.2
► Switch the lawn mower off.
► Place the lawn mower on a level surface.
► Open the discharge flap and hold it open.
► Remove the grass catcher box upwards by the

7 Assembling the Lawn Mower

dlebar (2) so the pin (4) engages in the
hole (3) on both sides.
them so the screw head is flush with the lower
handlebar (2) on both sides.
and tighten.
Fitting and Removing the
Grass Box
Engaging the grass catcher box
batteries.
sion, 7.4.2.
mulching insert, 7.3.2.
handle (3) and attach the hook (4) to the
shaft (5).
catcher box (2).
Detaching the Grass Catcher Box
handle.
0478-131-9977-A