Led Diagnostics; Leds On The Battery; Battery Status; Charge Status - Stihl Rma 460.0 V Notice D'emploi

English
– e = 0.4 in. (9 mm)
– f = 0.1 in. (2.5 mm)

10 LED Diagnostics

10.1 LEDs on the Battery

10.1.1 Battery Status

Four LEDs show the status of the battery. These LEDs can
glow or flash green or red.
If one LED glows red continuously: the battery
is either too hot or too cold. Allow the battery
to warm up or cool down gradually at an
ambient temperature of about 50 °F to 68 °F
(10 °C to 20 °C).
If all 4 LEDs flash red: the battery has a
malfunction and must be replaced. Do not
attempt to charge, use or store the battery.
10.1.2 Lawn Mower Status
When the battery is inserted in the lawn mower, the same
LEDs on the battery will indicate the status of the lawn
mower.
If three LEDs glow red continuously: the lawn mower motor
is too hot. Allow the motor to cool down.
If three LEDs flash red when you activate the trigger switch:
the lawn mower has an electrical malfunction. Do not
operate the lawn mower. Have it checked by an authorized
STIHL servicing dealer before use or storage.
For troubleshooting information, @ 24.

10.1.3 Charge Status

The LEDs on the battery also show the battery's state of
charge.
20
To determine the battery's state of charge:
1
► Press the button (1) on the battery.
The LEDs on the battery will glow or flash green for about
5 seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.

11 Assembling the Lawn Mower

11.1 Mounting the Handle

WARNING
Make sure the fuse key and battery are removed before
starting assembly.
WARNING
To reduce the risk of injury from loss of control, ensure that
the handle is properly and securely mounted before starting
work. The lower handle and upper handle can be folded
down after rotating the handle knobs. Check that the star
knobs are firmly tightened. Hold the handle at the highest
point with one hand and rotate the handle knobs. Use
caution and avoid pinching fingers between the parts.
10 LED Diagnostics
80-100%
60-80%
40-60%
20-40%
0-20%
0458-818-8221-A