Leds On Battery; Activating And Deactivating Bluetooth® Radio Interface; Assembling The Lawn Mower; Attaching The Handlebar - Stihl Rma 353.0 V Notice D'emploi

7 Activating and Deactivating Bluetooth® Radio Interface
6.2 Displaying the charge level
1
► Press the button (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
20.1.
There is a malfunction in the mower or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
0478-131-9980-A
80-100%
60-80%
40-60%
20-40%
0-20%
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
8 Assembling the Lawn
Mower
8.1

Attaching the handlebar

WARNING
■ When attaching the handlebar, fingers or other
body parts may get caught between the parts
of the handlebar.
► Work carefully.
► Switch off the lawn mower and remove the
batteries.
► Place the lawn mower on a level surface.
► Align the upper part of the handlebar (1) and
bottom part of the handlebar (2) so the
stud (4) engages in the bore (3) on both sides.
► Insert the screws (5) on both sides and align
them so the screw head is flush with the bot‐
tom part of the handlebar (2) on both sides.
► Screw on the star knob nuts (6) on both sides
and tighten firmly.
► Push the cable (7) into the retainer (8).
The handlebar does not need to be removed
again.
8.2 Fitting and Removing the
Grass Box
8.2.1 Engaging the grass catcher box
► Switch off the lawn mower and remove the
batteries.
► Place the lawn mower on a level surface.
► If an extension is attached, detach the exten‐
sion, 8.4.2.
► If a mulching insert is in place: remove the
mulching insert,
English
8.3.2.
11