Use
pressure
ous example to add vibrato with key pressure/aftertouch.
1. In the
modulation
knob next to the display to scroll to Mod Slot 1 if it's not already displayed.
2. Use the
parameter
to scroll through the various mod sources and choose
3. Use the
parameter
scroll through the various mod destinations and choose
4. Hold down a note on the keyboard (or press the
note on the keyboard) and turn the mod wheel.
5. Use the
parameter
to set the amount to your preference. Higher
Use
pressure
with key pressure/aftertouch.
Other modulation ideas:
•
Route
3 to
env
time your press a key. This technique is often used to create the "attack
pitch blip" effect in classic synth brass sounds.
•
Route an LFO to
controlled by the modulation amount. Panning speed is controlled by
the LFO frequency. Add a second mod path to control the LFO speed
with the Mod Wheel for a faux rotating speaker spin-up/spin-down
effect. Enable the chorus effect and set up a third mod path to control
with the mod wheel for even better results.
fx mix
•
Route the mod wheel to
frequencies and/or waveshapes. Then transition between them with the
mod wheel. Set
way to simulate a guitar feedback effect, especially on sounds that use
the distortion effect. Oscillator 1 could be the main tone and Oscillator
2 could be the "feedback harmonic." Set up a second mod path to also
add vibrato with the mod wheel.
34
Modulation
as the modulation source instead of the mod wheel in the previ-
section, press the
source
knob to select the
source
knob to select the
knob to select the
amount
as the modulation source instead of the mod wheel in the previ-
amount
to create a rising or falling pitch effect each
osc all freq
to create an auto-panning effect. Panning width is
pan
and set Oscillator 1 and 2 to different
osc mix
1/2 mix to 0 and
osc
mod amount
button. Use the
parameter
value
mod wheel
dest
value
cutoff
button and play a
hold
value
settings cause the
amount
to 127. This is one
Dave Smith Instruments
knob
.
knob to
.
knob
)
amount