Dave Smith Instruments Prophet REV2 Mode D'emploi page 74

Modulation Parameters
Selects a modulation source. The are twenty-two different
Source:
modulation sources. See page 69 for a complete list.
Destination:
ent modulation destinations. See page 70 for a complete list.
Sets the modulation amount. Modulation can be either positive
Amount
or negative.
Modulation Examples
Below are several modulation scenarios that illustrate how to use the modu-
lation matrix. The examples provide full, step-by-step instructions for clarity.
In actual practice, there are shortcuts for routing modulation to various
front panel sources/destinations. Simply hold down the
and move the control you want to use as a source (the mod wheel, for
example). Then hold down the
the amount using the
Be aware that not all front-panel controls can be used as a modulation
sources/destinations.
To use the mod wheel to add vibrato:
1. In the
low frequency oscillators
set
frequency
(You will control the amount with the mod wheel.)
2. In the
modulation
knob next to the display to scroll to Mod Slot 1 if it's not already
eter
displayed.
3. Use the
parameter
to scroll through the various mod sources and choose
4. Use the
parameter
to set the amount to 30.
5. Use the
parameter
scroll through the various mod destinations and choose
6. Hold down a note on the keyboard and turn the mod wheel. You should
hear vibrato.
Prophet Rev2 User's Guide
destination
and
parameter value
section, set LFO 1 to
to 75. Set to
destination
section, press the
source
knob to select the
source
knob to select the
amount
knob to select the
dest
button
source
button and move the control
knobs next to the display.
triangle
. Set
osc all freq amount
button. Use the
param
value
mod wheel
value
value
1
lfo amt
Modulation
-
and
to 0.
-
knob
knob
knob to
.
33