Dave Smith Instruments Prophet REV2 Mode D'emploi page 158

Appendix D: Troubleshooting
and Support
Troubleshooting
If you're experiencing problems or unexpected behavior from your
Prophet Rev2, here are a few typical scenarios and their solutions:
1. Initialize a basic preset by holding the Transpose
and pressing the
2. If the problem is still there, check the following:
• Master Volume - make sure it is set to an appropriate value
• Rear-panel output jacks - make your audio cables are connected to
.
output
• In the menu, make sure that
global
If the sequencer or arpeggiator has stopped running:
• Check the
midi clock mode
Rev2 is set to
master
/ , make sure the Prophet Rev2 is receiving MIDI clock.
no s s
• In the Global menu, check
t . Also, check the mod wheel position. The mod wheel can
emperament
do more than just add vibrato. Also, check the
in the menu to ensure the Prophet Rev2 is set to
global
Or if set to
slave
Rev2 is receiving MIDI clock.
• USB can cause ground loops, so try to resolve any grounding issues
between the computer and the Prophet Rev2. Or use MIDI, which is opto-
isolated.
Prophet Rev2 User's Guide
button.
hold
local control
setting in
global
or . Or if set to
off slave
and make sure it's set to e
alt tunings
or or
slave thru slave no s
Appendix D: Troubleshooting and Support
.
and buttons
down up
main
is set to .
on
to ensure the Prophet
or or
slave thru slave
setting
midi clock mode
or
master
/ , make sure the Prophet
s
/
a
qual
.
off
75