Dave Smith Instruments Prophet REV2 Mode D'emploi page 70

The LFOs can be free-running or synced to the arpeggiator, sequencer, or
Shape: Triangle, Sawtooth, Reverse Sawtooth, Square, Random
button sets the waveshape of the selected LFO.
Sets the frequency of the selected LFO from a slow .022Hz
Frequency:
to a fast 500Hz. This is affected by the
as explained below.
When on, the LFO synchronizes with the master clock, which
Clk Sync:
controls the arpeggiator, sequencer, and certain effects.
Routes the selected LFO to one of the many modulatable
Destination:
destinations within the synthesizer. You can also use the modulation
matrix to route an LFO to additional destinations.
Sets the amount of LFO modulation routed to the selected
Amount:
destination. Setting an amount here applies the selected modulation
continuously. You can also use the modulation matrix to route an LFO
to additional destinations and use a different modulation amount if you
want.
When enabled, this makes the LFO wave cycle reset when
Key Sync:
you press a key (but is not reset if you press a key while other notes are
held).
There is a shortcut for routing an LFO to a front-panel destination (provided
that the destination is a valid destination). Simply hold down the selector button of the
desired LFO, then and move the knob or control you want to use as a destination (the
not all front-panel controls can be used as a modulation destinations.
Prophet Rev2 User's Guide
(clock sync) parameter
clk sync
knobs. Be aware that
amount
Low Frequency Oscillators
—This
31