Dave Smith Instruments Prophet REV2 Mode D'emploi page 38

Sets the method by which
7. MIDI Param Receive: Off, CC, NRPN—
parameter changes are received via MIDI. As with transmission, NRPNs
are the preferred method.
When On, the synth will respond to
8. MIDI Control Enable: Off, On—
MIDI controllers, including Pitch Wheel, Mod Wheel, Pedal, Breath,
Volume, and Expression.
When On, the synth will respond
9. MIDI Program Enable: Off, On—
to received MIDI Program Change and other SysEx messages, and will
transmit them (when prompted) to the MIDI Out. See Sysex Messages on
page 90 for details.
Sets the port, MIDI or
10. MIDI Sysex Cable: None, MIDI Port, USB—
USB, by which System Exclusive data will be transmitted and received.
Sets the port by which
11. MIDI Out Select: Off, MIDI, USB, MIDI+USB—
MIDI data will be transmitted.
Multi Mode allows separate MIDI control of
12. Multi Mode: On, Off—
voices 1-8 and voices 9-16 on 16-voice systems. (On 8-voice systems
this is voices 1-4 and voices 5-8.) This enables independent, bi-timbral
control of the Prophet Rev2.
When Multi Mode is on, the Prophet Rev2 responds to MIDI data on two
consecutive MIDI channels — the base channel (selected in the Global
menu) and the next highest channel. The base channel controls voices 1-8
(or 1-4 on 8-voice systems) and the other channel controls voices 9-16
(or 5-8 on 8-voice systems). Notes, program changes, and other MIDI
the two parts.
Note that a program change needs to be sent to each of the two chan-
nels when setting up Multi Mode. Only Layer A of the selected program
is loaded. There are no stacks or splits in Multi Mode. Use CCs or
Layer A NRPNs for automation of parameters. Program Layer B data is
completely ignored in Multi Mode
Prophet Rev2 User's Guide Global Settings 15