Publicité
Les langues disponibles
Les langues disponibles
Programming the Gated Sequencer
To program a gated sequence:
1. Press the
2. Press the
3. Use the
4. Press the
5. Use the
6. Use the
7. Repeat steps 5-6 as necessary to create the rest of the gated sequence.
8. When you're done, hold down a key to listen to your sequence.
9. To save the sequence, save the program and they are saved together.
create non-repetitive modulations. For example, if track 1 utilizes the full 16 steps, set
track 2 to repeat after 12 steps (by setting step 13 to
in the modulation matrix. This means that you can route a gated sequencer track to
multiple destinations.
Prophet Rev2 User's Guide
button and toggle to the gated sequencer.
type
button and use the
mode
mode. See "Sequencer Parameters" on page 48.
knob to select desired track.
track
button and use the
destination
desired destination.
knob to navigate to step 1 (or any desired step,
parameter
1-16).
knob to enter a value from 0-125. Choosing
value
the end of the sequence if you want to use fewer than 16 steps. The
sequence will loop when it reaches that step.
(See "Saving a Program" on "Saving a Program" on page 4.)
Try using different sequence lengths on different gated sequencer tracks to
Gated sequencer tracks are also modulation sources and appear as such
.
knob to select the desired
value
knob to select the
value
).
reset
Sequencer
marks
reset
47
Publicité
