Signature STI3B/2 Instructions D'utilisation page 76

There are ventilation holes around outside of the hob.
YOU MUST ensure these holes are not blocked by the
worktop when you put the hob into position.
Be aware that the glue that join the plastic or wooden

material to the furniture, has to resist to temperature
not below 150℃, to avoid the unstuck of the paneling.

The rear wall, adjacent and surrounding surfaces must
therefore be able to withstand an temperature of 90℃.
9.2 Before installing the hob, make sure that

The work surface is square and level, and no structural
members interfere with space requirements.

The work surface is made of a heat-resistant and
insulated material.

If the hob is installed above an oven, the oven has a
built-in cooling fan.

The installation will comply with all clearance
requirements and applicable standards and
regulations.

A suitable isolating switch providing full disconnection
from the mains power supply is incorporated in the
permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
EN-32