Invacare Aquatec KOGIA Manuel D'utilisation page 14

Aquatec® KOGIA
IMPORTANT!
Risk of damage
– The hand control may only be used when the backrest
is properly installed and in the upright position.
IMPORTANT!
If the battery is not sufficiently charged, the indicator
lamp B lights up red when the Down button E is
pressed. In this case, the lowering function of the bath
lift is disabled. You can however still raise the lift.
– Recharge the battery immediately after raising it.
Raising the bath lift
IMPORTANT!
If the backrest is lowered, it will move into the upright
position first.
1. Press the Up button C on the hand control and keep it pressed.
The backrest moves into the upright position or the seat moves
upwards.
When moving the backrest into the upright position, slight
crackling noises are possible.
2. Release the Up button on the hand control.
The bath lift stops in the current position.
Lowering the bath lift
IMPORTANT!
If the seat is already lowered, the backrest lowers
towards the rear.
14
1. Press the Down button E on the hand control and keep it
pressed.
The seat moves downwards or the backrest lowers towards
the rear.
2. Release the Down button on the hand control.
The bath lift stops in the current position.
Emergency stop button
IMPORTANT!
Only press the emergency stop button A if the device
does not stop immediately when the Up or Down
button is released (e.g. if a button jams). The bath lift
stops moving immediately and the red light integrated in
the hand control flashes briefly.
If the lifter no longer responds when pressing the Up or Down
buttons after releasing the emergency stop button, the error has
not been corrected. The device is not ready for use and must be
repaired, for example, in case of an electronic damage.
Contact your specialist dealer, if necessary.
1584939-A