Power On Self-Test (Post) - Bosch MTS 6512 VCI Notice Originale

5.4

Power On Self-Test (POST)

When you first apply power to the VCI, the Power On
Self-Test (POST) runs. You should observe a sequence
of lights and hear the "BEEP' indicating that the VCI is
working properly.
Four Light Emitting Diodes (LEDs) are located on the
front of the MTS 6512 VCI Diagnostic Tool. The Vehicle
LED flashes green when the VCI communicates with
the vehicle. The Host LED flashes green when the VCI
is communicating with the PC. The Error LED illumi-
nates red when a problem with the VCI is detected. The
Power LED illuminates green when the VCI has booted
and is ready for use.
When the start-up phase is finished the green Power
LED is permanently on. In Active state the Vehicle LED
and the HOST LED are flashing. The red Error LED is
turned on when a problem occurs.
5.5 Connecting the VCI to a Vehicle
The MTS 6512 VCI Vehicle Communication Interface
kit contains the J1962 16/26 pin Data Link Connector
(DLC) cable to connect the VCI to the vehicle.
Refer to the electrical wiring diagram for the vehicle you
are testing to determine the location and type of Data
Link Connector (DLC) installed on the vehicle.
1. Connect the 26-pin end of the DLC cable to the bot-
tom of the VCI, then tighten the screws.
2. Connect the 16-pin end of the DLC cable to the
vehicle DLC connector.
Powering the VCI
The VCI can be powered by the vehicle's 12-volt battery
or by the USB cable connected to your PC.
To use the Vehicle Battery, connect the VCI directly to
the vehicle using the DLC cable.
To use USB power, connect the VCI to your PC using
the USB cable.
Robert Bosch GmbH
6. Finishing Up
After using the MTS 6512 VCI, a few simple steps help
you leave the vehicle electronic system(s) in the proper
state and ensure that you get the most use out of your
diagnostic tools:
1. Before turning the VCI off, exit any running PC com-
puter applications.
2. Turn the VCI off by pressing the on/off button. The
Power LED turns off.
3. Disconnect the VCI's J1962 16/26 Pin DLC cable
from the vehicle.
4. Disconnect the USB cable from the PC and the VCI.
5. Store the VCI, cables, and other parts in a secure,
dry location.
| MTS 6512 VCI | 27 en
|
1 699 200 011 2014-08-27