Programming The Coffee Measures (Only Dt Version); Programming The Drying Time (When Provided) - LaCimbali M24 Utilisation Et Installation

16. Programming the coffee measures (only DT version)

How to access the programming function
To enter the programming mode, press push button (18)
and keep it pressed for about 8 seconds; the blinking LED
light sequence above the keys and the intermittent buzzer
indicates that the machine is in the programming phase.
To exit the programming mode, after programming the
various drinks, press push button (18) again.
"Before programming the coffee dispensing
correct serving of ground coffee.
Don't use coffee grouts for programming
servings."
unit, positioning the cup (or cups) under the nozzle (or
Press (and keep momentarily pressed) the coffee dispensing
push button (16, 17, 19 or 20) corresponding to the required
serving to be programmed; the LED of the key to be
programmed stays on and does not blink.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new
dose of ground coffee and repeat the operation.
The drying phase allows the coffee dispensing panel to dry
and sends water inside of it to the drain tube.
At the end of each dispensing cycle, the drying time counter
To program a longer or shorter drying time, please follow
these steps:
- Press and hold down any STOP/prog (18) key for about
8 seconds. The sequenced blinking LED lights above
the keys and the intermittent buzzer indicate that the
machine is in the "coffee dose" programming phase;
- Press and hold down the STOP/prog (18) key for the left
dispensing group: a different buzzer sound indicates that
the machine is in the drying time programming phase;
- Press any dispensing key (16, 17, 19 or 20) and hold it
down for the seconds you want to assign for the drying
time. Afterwards, release the key;
- At the end of the "drying time " programming procedure,
press a STOP/prog (18) key to return to the coffee dose
programming level;
- Press a STOP/prog (18) key again to exit the programming
menu.
Note: Accessing the Drying Time programming screen
zeros the 5 second factory setting for all keys.
10) on the coffee dispenser
10).

16.1 Programming the Drying time (when provided)

16
19
Start
dispensing
Dispensing
EV ON
Dispensing Time
12 EN
18 17
20
10
Dispensing
Drying Drying
EV ON
Drying time