Delivery Of The Coffee; Programming The Coffee Measures - LaCimbali M24 Select Utilisation Et Installation

10), empty out any coffee grouts
grinder/doser presser.
unit, positioning the cup (or cups) under the nozzle (or
Press the coffee dispensing push button (16, 17, 19, 20) for
the required serving; the machine will stop automatically.
Press the push button (18) for continuous dispensing.
Dispensing, whether for dosed servings or in the continuous
dispensing mode, can be interrupted at any time by pressing
the STOP push button (18).
How to access the programming function
To enter the programming mode, press push button (18)
and keep it pressed for about 8 seconds; the blinking LED
light sequence above the keys and the intermittent buzzer
indicates that the machine is in the programming phase.
To exit the programming mode, after programming the
various drinks, press push button (18) again.
"Before programming the coffee dispensing
correct serving of ground coffee.
Don't use coffee grouts for programming
servings."
unit, positioning the cup (or cups) under the nozzle (or
Press (and keep momentarily pressed) the coffee dispensing
push button (16, 17, 19 or 20) corresponding to the required
serving to be programmed; the LED of the key to be
programmed stays on and does not blink.
When the amount of coffee in the cup reaches the required
level, release the coffee dispensing push button.
Repeat the above operations for the other coffee push
buttons.
Note: if you make a programming mistake, use a new
dose of ground coffee and repeat the operation.

12. Delivery of the coffee

10) on the coffee dispenser
10).

13. Programming the coffee measures

10) on the coffee dispenser
10).
11 EN
16 18
19
10
16 18 17
19 20
10
17
20