Delivery Of The Coffee; Other Hot Beverage - LaCimbali M24 Utilisation Et Installation

10), empty out any coffee grouts
grinder/doser presser.
unit, positioning the cup (or cups) under the nozzle (or
DT version. Press the coffee dispensing push button (16,
17, 19, 20) for the required serving; the machine will stop
automatically.
Press the push button (18) for continuous dispensing.
Dispensing, whether for dosed servings or in the continuous
dispensing mode, can be interrupted at any time by pressing
the STOP push button (18).
C version. Press the coffee dispensing button (2) and
dispense.
When the desired dose is obtained, press button (2) again
to stop dispensing.
Scalding hazard! Use the appropriate
insulating devices (A) to move the water and
steam wands.
Steam dispensing
Complete immerse the left or right steam nozzle (6) (if
supplied) in the container with the beverage to be heated.
Turn the steam adjustment knob (7) counter-clockwise.
Wait until the beverage has reached the desired temperature.
Afterwards, turn the knob (7) clockwise to stop the steam
from exiting.
Cleaning of steam dispensing pipes
At the conclusion of each steam dispensing
phase:
- Using a clean sponge, wash with hot water
removing any organic residue present. Rinse
carefully.
- clean the inside of the steam nozzle as
follows:
Turn the nozzle towards the cup tray and
carefully activate steam dispensing at least
once.
Heating milk for frothy coffee (cappuccino)
General indications
Milk is a delicate biological product and can easily
at a storage temperature no higher than 5°C (41°F) from
the moment the container is opened and throughout its
entire period of use. Our storage appliances are suitable
for this purpose.
NOTE: at the end of the work day (or not more than 24
hours from the time the container is opened),

13. Delivery of the coffee

10) on the coffee dispenser
10).

14. Other hot beverage

DT
C
9
8
A
any remaining milk must be discarded.
Then plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for
a few seconds.
are reached, stop the steam by turning the knob (7) in the
opposite direction.
When the steam jet pipe (6) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Dispensing hot water
Place a container beneath the hot water tube (8) and turn
the hot water dispensing knob (9) counter-clockwise.
When the desired amount is reached, stop the hot water
by turning the knob (9) clockwise.
16 18 17
19 20
10
2
10
7
A
6